So I have finally decided to work on showing you the first steps in building your own PC. I selected major components before entering the store and then was "assisted" by the sales person to make sure I didn't have compatibility issues. (I say assisted because I went into the store originally to ONLY get the video card, and I walked out with everything for the entire computer. Some things could be better had I slowed down and considered the pro's and con's) Now I had a PC to put together; I also kept my budget under $500 not including the mail in rebates that I got. Since I started with a lengthy post on the brain of the computer, that is where I started with the build.
Now I was ready to start putting the pieces together. Starting with placing the processor on the mother board along with the CPU heat sink (the cooling block that keeps the processor chips heat down). I thought that this process would be slightly more complicated then it actually turned out to be and in reality I made it more difficult the first time around.
Here is the mother board out of box and package, along with a close up of the processor in the socket before installing the heat sink.
Installing the heat sink at this point is very easy and the one that came with the CPU actually had thermal material already on it. I cleaned it off to use "better" thermal paste, looking back it was absolutely unnecessary. (Those individuals who have used thermal paste in the past can criticize the application all you want; however there is no evidence that one method of application yields better results than another. Thermal paste is designed to fill in minute spaces between the heat sink and the processor creating a more complete seal between the two to allow for greater heat displacement. That being said too much thermal paste is a bad thing since it could ultimately insulate the processor and have the opposite effect that it was designed for.) I had to redo the installation of the heat sink after I used too much thermal paste the first time, for this reason I should have just used the heat sink out of the box that already had a pre-spread amount of thermal compound on it.
There are two clips on the side of the heat sink that firmly connect it to the mother board that are connected to the harness (the black plastic thing surrounding the processor). Once connected to the motherboard you need to find where the CPU fan connects and plug it in to the correct end and VOILA. That's how complicated the process is.
| The Finished Product of the Installation of The CPU and Heat Sink |
Things to consider: a new mother board will have documentation in the box that details how to install the processor, its very important to have this on hand, as well as looking over the specifications again before attempting installation. If the socket on the mother board does not match the pins on the processor you could damage the mother board, the processor or both. Check and re-check before connecting components should ensure that you don't wast time and money having to replace what was broken by trying to rush through the process.
I would like to hear from my audience what there thoughts are. What challenges have you had in following this build? Where can I clarify the process more fully?
No comments:
Post a Comment